27 21 030 Replacing radial shaft seal for output to the front axle (ATC 45L)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

23 0 490
27 1 470
2 318 114

IMPORTANT: After completion of the repair work, CHECK GEARBOX OIL LEVEL .
For these transfer boxes, use approved TRANSMISSION OIL only.

Necessary preliminary tasks:

Remove front PROPELLER SHAFT .

Remove protective cap (1) with a screwdriver.

Fig 1: Removing Protective Cap

G09958718

Courtesy of BMW OF NORTH AMERICA, INC.

Drive a hole into radial shaft seal (1) using a center punch (2).

IMPORTANT: Do not use a drill as drillings may result in transmission malfunction.

Fig 2: Removing Radial Shaft Seal

G09958719

Courtesy of BMW OF NORTH AMERICA, INC.

Screw in special tool 23 0 490.

Drive out radial shaft seal (1) with impact weight (2).

Fig 3: Identifying Special Tool (23 0 490)

G09958720

Courtesy of BMW OF NORTH AMERICA, INC.

Drive in radial shaft seal with special tool 2 318 114 .

Fig 4: Identifying Special Tool (27 1 470)

G09958721

Courtesy of BMW OF NORTH AMERICA, INC.

Reassemble the vehicle.

Check oil level.

Check transmission for leaks.