27 21 010 Renewing radial shaft seal for drive flange (ATC 45L)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

23 0 490
27 1 430

IMPORTANT: After completion of work, CHECK TRANSMISSION OIL LEVEL and top up if necessary.
For this transfer box, use approved TRANSMISSION OIL only.

Necessary preliminary tasks:

Remove TRANSFER BOX .

Drive a hole into radial shaft seal (1) using a center punch (2).

IMPORTANT: Do not use a drill as swarf may result in transmission failure.

Fig 1: Drilling Hole Into Radial Shaft Seal

G04745123

Courtesy of BMW OF NORTH AMERICA, INC.

Screw special tool 23 0 490 into radial shaft seal.

Drive out radial shaft seal (1) with impact weight (2).

Fig 2: Pulling Out Radial Shaft Seal

G04745124

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Coat sealing lips of new radial shaft seal with clean transmission oil.

Drive in radial shaft seal with special tool 27 1 430 .

Fig 3: Installing Radial Shaft Seal With Special Tool (27 1 430)

G04745125

Courtesy of BMW OF NORTH AMERICA, INC.

Reassemble the vehicle.

Check oil level.

Check transmission for leaks.