27 10 070 Replacing output flange on rear transfer box (ATC 45L)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: After completing work, check TRANSMISSION OIL LEVEL and top up if necessary.
Use only the approved TRANSMISSION OIL .

NOTE:

Replace output flange only together with a new radial shaft seal.
Procedure for removing output flange is identical to replacing RADIAL SHAFT SEAL .

Installation note:

Thickness of new shim must be determined before output flange is installed.

Determine and note down dimension A of output flange (old and new).

Fig 1: Checking Output Flange Dimension A

Courtesy of BMW OF NORTH AMERICA, INC.

Determine and note down dimension B of output flange (old and new).

Fig 2: Checking Output Flange Dimension B

Courtesy of BMW OF NORTH AMERICA, INC.

Determine old dimension C, thickness of shim.

Fig 3: Measuring Shim Thickness

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Calculate thickness of new shim:

Add old dimension A of output flange (previous) and old dimension C of shim Then subtract old dimension B from old result A+C
Subtract dimension B from dimension A of output flange (new)
Then subtract result of step 2 from result of step 1.