52 26 008 Removing and installing/replacing side section of rear seat backrest (through-loading facility) on left or right

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Tilt rear seat backrest forwards.

Detach cover (1) upwards.

Remove seat belt strap (2) from capping (1).

Fig 1: Removing Seat Belt Strap From Capping

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Latch mechanisms (1) of cover (2) must not be damaged.

Fig 2: Identifying Latch Mechanisms Of Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Pop out cover (1) for seat backrest bracket.

Installation note:

Insert cover (1) at bottom and pop in at top left and right in succession.

Fig 3: Removing Cover For Seat Backrest Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock latch (1) with a screwdriver through side wall.

Pull backrest side section (2) forwards and lift out.

Fig 4: Pulling Backrest Side Section Forwards

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

First thread in guides on the backrest side section (1) in the supports on the body.
Then press down side section of backrest (1) so that the guides fit properly in the supports.
Clip backrest side section at top into place.

Fig 5: Identifying Guides On Backrest Side Section
Courtesy of BMW OF NORTH AMERICA, INC.