54 10 170 Removing and installing front glass slide/tilt sunroof panel
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The following steps can be carried out in passenger compartment with the glass roof panel fully closed.
Open floating roofliner fully.
Make sure that grease at the ends of the rail do not come into contact with the roofliner.
Not necessary for replacement:
Before removing the Torx screws, make a mark around the washer in order to ensure correct alignment during installation.
Open floating roofliner fully.
Make sure that grease at the ends of the rail do not come into contact with the roofliner.
Not necessary for replacement:
Before removing the Torx screws, make a mark around the washer in order to ensure correct alignment during installation.
Installation note:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of curing)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use
To unscrew Torx screws (see next work step) press side cover seal (1) downward in the marked area.
Side cover seal (1) must not be damaged or soiled.
Replace side cover panel (1) if necessary.
IMPORTANT:
Risk of damage!
To avoid scratches, do not rest glass slide/tilt sunroof panel on glass surface.
To avoid scratches, do not rest glass slide/tilt sunroof panel on glass surface.
Release Torx screws (1).
Installation note:
Replace Torx screws and insert with Loctite.
Align shims to marks.
Screw down glass slide/tilt sunroof panel.
Tightening torque 54 12 01AZ .
IMPORTANT:
A second person is required to help in removing and installing the glass slide/tilt sunroof panel!
Lift out glass slide/tilt sunroof panel (1).
Installation note:
Tape off installation area on left and right at roof aperture with fabric adhesive tape.
Install glass slide/tilt sunroof panel carefully (twist in) as gasket can be damaged during installation.
Check glass slide/tilt sunroof panel for correct ALIGNMENT and adjust if necessary.