18 10 031 Replacing the rear silencer (N47D20 O1)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 31 2 220
WARNING:
Risk of burning!
Only perform this repair work after engine has cooled down.
Danger of injury!
Removal of the exhaust system must be carried out with the assistance of a second person.
Only perform this repair work after engine has cooled down.
Danger of injury!
Removal of the exhaust system must be carried out with the assistance of a second person.
Support the rear silencer with a jack and special tool 31 2 220 and secure against falling out.
NOTE:
If the separation point line is not marked by a punch mark in the pipe, determine the separation point by means of the pipe length on the new rear silencer.
Carry over separation point to faulty rear silencer and mark.
Secure rear silencer against falling off.
Cut through exhaust pipes at marked point with a suitable tool.
Carry over separation point to faulty rear silencer and mark.
Secure rear silencer against falling off.
Cut through exhaust pipes at marked point with a suitable tool.
Release bolt and remove holder (1).
Tightening torque: 18 20 3AZ .
Release nuts (1) and remove holder.
Tightening torque: 18 20 4AZ .
Unscrew nuts (1).
Tightening torque: 18 20 4AZ .
Lower and remove the rear silencer carefully with assistance of a second person.
Installation note:
Adjust rear silencer and connect with clamp.
Center clamp and tighten down.
Tightening torque: 18 31 3AZ .
Installation note:
Check rubber mount for damage, replace if necessary.
Check exhaust system for leak tightness.