18 00 020 Removing and installing complete exhaust system (N47 D20 O1)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 31 2 220
WARNING:
Risk of burning!
Only perform this repair work after engine has cooled down.
Danger of injury!
Removal of the exhaust system must be carried out with the assistance of a second person.
Only perform this repair work after engine has cooled down.
Danger of injury!
Removal of the exhaust system must be carried out with the assistance of a second person.
Support exhaust system with jack and special tool 31 2 220 and secure against falling out.
Unfasten nut.
If necessary, replace clamp.
Part: Clamp
Tightening torque: 18 31 2AZ .
Release bolt and remove holder (1).
Tightening torque: 18 20 3AZ .
Release nuts (1) and remove holder.
Tightening torque: 18 20 4AZ .
Unscrew nuts (1).
Tightening torque: 18 20 4AZ .
Lower and remove exhaust system carefully with assistance of a second person.
Installation note:
Check rubber mount for damage, replace if necessary.
Check exhaust system for leaks.