51 13 280 Removing and installing/replacing trim strip on roof frame at left or right
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
Graphics are similar.
Lever out trim strip (1) with special tool 00 9 321 starting at the front.
Unclip trim strip (1) in direction of arrow.
Installation note:
Latch mechanisms (1) of clips (2) must not be damaged.
If necessary, replace the clips (2).
Emergency strategy if T-bolt is broken:
Installation note:
Place front trim strip (2) against seal (1).
Trim strip (2) must be flush with edge (3) at rear.
Clip trim strip (2) into place completely.