51 43 201 Removing and installing or replacing trim for roof pillar at front (A-pillar), left or right
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Follow SAFETY INSTRUCTIONS
for working on vehicles with airbag systems.
IMPORTANT:
Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).
Detach edge protection (1) in area of trim panel (2).
Detach trim panel (2) from the first detent position of the clamp (4) toward the inside.
Loosen the trim panel (2) toward the top and thereby detach it from the clips (3).
Feed out trim panel (2) from dashboard and remove.
Installation note:
Make sure EDGE PROTECTION (1) is correctly seated.
Always replace clamps (4).
Installation note:
Always replace clamps (2).
Pry out any clips (1) remaining in the body and insert in cover
Replace faulty clips (1).
Make sure guides (3) is correctly seated in associated mounts.