51 42 019 Removing and installing or replacing door handle on door trim panel, rear left or right

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 317

When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).

Necessary preliminary work:

REMOVE rear door trim panel

Undo screws (3) and (4).

Release retaining hook at upper and lower dome of handle (2).

Feed handle outwards out of door trim panel (1).

Fig 1: Locating Door Trim Panel Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Retaining catches (1) on handle (2) must not be damaged or missing.

Replacement

Reinstall retaining clips (3) for handle trim cover

Fig 2: Identifying Door Handle Locking Hooks
Courtesy of BMW OF NORTH AMERICA, INC.