51 22... Replacing inside door opener on left or right rear door
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).
Necessary preliminary work:
- Detach Bowden cable for inner door opener . See 51 21 235 REMOVING AND INSTALLING/REPLACING BOWDEN CABLE FOR INSIDE DOOR OPENER ON LEFT OR RIGHT FRONT DOOR or 51 22 235 REMOVING AND INSTALLING/REPLACING BOWDEN CABLE FOR INSIDE DOOR OPENER ON LEFT OR RIGHT REAR DOOR
Version with roller sunblind only
- Remove ROLLER SUN BLIND
NOTE:
The graphic shows the left door trim panel.
If necessary, unclip and remove tweeter (4).
Release round weldings (1) with a Ø 12 mm drill.
Release long welding (2) with a box cutter.
Lever out inside door opener housing on door trim panel (3) and set down.
Installation note:
Fold long retaining clip (2) over inside housing tab of the door opener and press tight.
Only with roller sunblind:
- Bend housing tab of door opener with retaining clip (2) upward at a slant until roller sunblind can be mounted.
Secure door handle to door trim panel (3) by pressing down round retaining clips (1).
Reinstall tweeter (4).