12 14 523 Replacing pulse sensor on intake camshaft (N52T)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary work:

Read out the fault memory of the DME control unit.
Switch off ignition.
Remove ACOUSTIC COVER

Release connector (1) and remove.

Release screw.

Installation note:

Replace screw.

Tightening torque 13 62 1AZ .

Remove pulse sensor (2).

Installation note:

Replace sealing ring.

Fig 1: Locating Pulse Sensor Screw

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault messages.
Delete fault memory.