61 31 117 Removing and installing/replacing power window switch (driver's side)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT DOOR TRIM PANEL, LEFT .

Clip out connector (1) from control panel wiring harness.

Release screws (2) from control panel fixture.

Hook switch cluster support forward out of door trim panel (3) while feeding out wiring harness for switch cluster.

Feed out.

Fig 1: Identifying Control Panel Fixture Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release retaining tabs (1) and clips (2).

Remove switch (3) in direction of arrow.

Installation note:

Retaining tabs (1) and clips (2) must not be damaged or missing.

Make sure switch (3) is correctly seated.

Fig 2: Releasing Retaining Tabs And Clips

Courtesy of BMW OF NORTH AMERICA, INC.