61 12 062 Replacing wiring harness for front bumper panel
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on HANDLING WIRING HARNESSES
and cables.
Necessary preliminary tasks:
- Remove FRONT BUMPER PANEL .
Release and disconnect plug connections in area (1).
Unlock and disconnect plug connections at the ultrasonic sensors.
Unclip wiring harness (3) in area (2).
Remove wiring harness (3).
Installation note:
Make sure wiring harness (3) is laid correctly.