33 21 020 Removing and installing/replacing both output shafts

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

The RADIAL SHAFT SEAL FOR THE OUTPUT SHAFT should be renewed every time the output shaft is removed and installed.
The circlip of the output shaft must be replaced after re-installation.

NOTE: The procedure is described in PRESSING OUTPUT SHAFT OUT OF DRIVE FLANGE AND DRAWING IN .

After installation:

Check FINAL DRIVE OIL LEVEL , correct if necessary.