31 12 026 Removing and installing/replacing guide joint in swivel bearing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary work:
- Remove TENSION STRUT FROM GUIDE JOINT .
IMPORTANT:
Check the rubber gaiter and circlip for damage!
When removing and installing the trailing link, check the seat of the circlip seal between the trailing link and the wheel control joint and replace the wheel control joint if needed!
When removing and installing the trailing link, check the seat of the circlip seal between the trailing link and the wheel control joint and replace the wheel control joint if needed!
Release screw (1).
Tightening torque 31 12 5AZ
Remove guide joint from swivel bearing.
Installation note:
Rework thread in swivel bearing.
Keep guide joint and bore hole in swivel bearing clean and free from oil and grease.
Replace microencapsulated screw.