31 60 535 Replacing two gaiters on output shaft(s) (output shaft(s) removed)

Grip output shaft (1) in vice with aluminium clamping jaws.

Fig 1: Removing Gaiters On Output Shaft

Courtesy of BMW OF NORTH AMERICA, INC.

Replacing gaiter of joint on wheel side: 

Release LOW PROFILE CLIP  (1) and clip (2).

Pull back rubber gaiter (3).

Installation note: 

Feed gaiter (3) into groove of joint.

Fig 2: Removing Low Profile Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Press off joint (1) via contact pressure of circlip on shaft (2).

Installation note: 

Replace circlip.

Push on joint until circlip can be heard to snap into place.

Fig 3: Identifying Circlip On Shaft And Joint Of Via Contact Pressure

Courtesy of BMW OF NORTH AMERICA, INC.

Lift out circlip (1).

Installation note: 

Install retaining ring (1).

Fig 4: Identifying Circlip

Courtesy of BMW OF NORTH AMERICA, INC.

Pull off gaiter (1) over shaft (2).

Carefully clean all components with a cloth.

Fig 5: Pulling Off Gaiter

Courtesy of BMW OF NORTH AMERICA, INC.

Replacing gaiter of joint on gearbox side: 

Release band clamps (1, 2).

Pull back rubber gaiter (3).

Detach joint housing (4).

Installation note: 

Feed gaiter (3) into groove of joint housing (4).

Align band clamp (1) so that hook fastener is as at flat end of joint housing (4).

Fig 6: Releasing Band Clamps

Courtesy of BMW OF NORTH AMERICA, INC.

Remove circlip (1).

Installation note: 

Install retaining ring (1).

Detach tripod element (2) from shaft (3).

Pull off gaiter over shaft (3).

Carefully clean all components with a cloth.

Fig 7: Identifying Retaining Ring, Circlip And Tripod Element

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Flat side (2) of tripod element (1) must point to circlip.

Fig 8: Identifying Tripod Element And Flat Side

Courtesy of BMW OF NORTH AMERICA, INC.