13 62 560 Removing and installing/replacing hot film air mass meter (N52T)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Read out the fault memory of the DME control unit.
Switch off ignition.

Release connector (1) and remove.

Unfasten screws (2).

Tightening torque: 13 62 8AZ .

Pull hot film air mass meter (3) out of upper section of intake silencer housing.

Fig 1: Identifying Connector, Screws And Hot Film Air Mass Meter

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault message.
Delete fault memory.