13 62 010 Removing and installing/replacing differential pressure sensor (N52T)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary work:

Remove ACOUSTIC COVER .

Unclip wiring harness (1) and lay to one side.

Unlock connector (2) and remove.

Release screws (3).

Tightening torque: 13 62 4AZ .

Pull differential pressure sensor (4) out of intake plenum.

Fig 1: Identifying Wiring Harness, Connector And Pressure Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Read out fault memory of control unit of Digital Motor Electronics (DME).

Check stored fault message.

Delete fault memory.