11 13 Oil sump
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATION - OIL SUMP
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | Plug Oil drain to oil sump. |
N52T | M12 x 1.5 | Replace sealing ring. | 25 Nm |
| 2AZ | ASA screw Oil sump (aluminum) to crankcase lower half. |
N52T | M8 x 26 | Replace screw. Thread repairs exclusively with aluminum Helicoil threaded insert. Joining torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 8 Nm | ||||
| Torque angle | 60 ° | ||||
| 3AZ | ASA screw Oil sump (aluminum) to crankcase lower half. |
N52T | M8 x 112 | Replace screw. Thread repairs exclusively with aluminum Helicoil threaded insert. Joining torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 8 Nm | ||||
| Torque angle | 60 ° | ||||
| 4AZ | ASA screw Oil sump (aluminum) to crankcase lower half. |
N52T | M8 x 92 | Replace screw. Thread repairs exclusively with aluminum Helicoil threaded insert. Joining torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 8 Nm | ||||
| Torque angle | 180 ° | ||||
| 5AZ | ASA screw Oil sump (aluminum) to crankcase lower half. |
N52T/All | M8 x 40 | Replace screw. Thread repairs exclusively with aluminum Helicoil threaded insert. Joining torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 8 Nm | ||||
| Torque angle | 90 ° | ||||
| 6AZ | ASA screw Oil sump (aluminum) to crankcase lower half. |
N52T/All | M8 x 36 | Replace screw. Thread repairs exclusively with aluminum Helicoil threaded insert. Joining torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 8 Nm | ||||
| Torque angle | 90 ° | ||||
| 7AZ | ASA screw Oil sump (sheet metal) to crankcase lower half. |
N52T | M8 x 24 | Replace screw. Thread repairs exclusively with aluminum Helicoil threaded insert. Joining torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 8 Nm | ||||
| Torque angle | 60 ° | ||||
| 8AZ | ASA screw Transmission to oil sump. |
N52T | M8 x 50 | 19 Nm | |
| 9AZ | Hexagon nut Oil level sensor to oil sump. |
N52T | M6 | 8 Nm | |
| 10AZ | Screw Transmission oil line to oil sump. |
N52T | M6 | 10 Nm | |
| 11AZ | Oil deflector to bed plate | N52T | M6 x 20 | ||
| Jointing torque | 4 Nm | ||||
| Torque angle | 90 ° | ||||