Install high pressure pump
- Feed in and install high pressure pump (2).
- Replace the bolts (arrows).
Parts : screw
- Position the screws (arrows) of the high-pressure pump (2) and tighten alternating
in 90°
-steps.
Compliance with this specification is imperative to make sure that the piston will not break due to twisting.
TIGHTENING TORQUES SPECIFICATION
| High pressure pump to cylinder head cover | ||
|---|---|---|
| M6X25 Replace screws. |
Tightening torque | 12 Nm |
- Connect and lock the connector (1).
The connector (1) must engage audibly.
Follow-up work
- Install fuel DELIVERY LINE .
- Install the HIGH-PRESSURE LINE between the high-pressure rail and the high-pressure pump.
- Install the IGNITION COILS .
- Install rear ACOUSTIC COVER .
- Install the upper part COWL .
- Install ACOUSTIC COVER .
- Install windshield panel COVER .
- Install left and right WIPER ARM .
- Install fan COWL .
- Install the rear top CROSS CONNECTION .
- Install the left and right hood gasket SEAL .
- Install the rear left and right engine compartment COVER PANEL .
- Install the front hood rear SEAL .
- Install the top left and right engine compartment COVER .
- Install the front UNDERBODY PROTECTION .
- Reconnect all battery GROUND LEADS .