Remove catalytic converter
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
Preliminary work
- Remove the ACOUSTIC COVER .
- Remove right FRONT-END STRUT .
- Remove intake silencer HOUSING .
- Remove the lambda OXYGEN SENSOR .
- Remove the OXYGEN SENSOR MONITOR .
- Remove the center UNDERBODY PROTECTION .
- Remove rear UNDERBODY PROTECTION .
- Remove left and right tank COVER .
- Remove the tunnel connecting SUPPORT .
- Remove EXHAUST SYSTEM .
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
CAUTION:
Heavy component.
Heavy components can lead to injury or damage.
Heavy components can lead to injury or damage.
- Remove and install heavy components with the aid of another person/other persons.
CAUTION:
Component with heavy weight.
Injury hazard!
Injury hazard!
- Note component's center of gravity.
- Support component using a jack.
- Secure component against falling off the jack.
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Detach pressure hose.
- Pull off the pressure hose (1) in arrow direction and set it aside.
- Loosen V-band clamp (1).
- Loosen nuts (1).
- Unlock and loosen clamp (1).
- Feed out catalytic converter and remove.