Install front pads (18-inch high brake)
- Remove the protective film of the adhesive layer (1) at the brake pads.
The adhesive layer (1) must not be taped.
- Insert brake pads into the brake caliper.
The adhesive layer must not tap the brake piston.
- Position the retaining clip (1).
- Drive in locking pins (2) in the direction of the arrow.
Adhesion of brake pads to brake pistons:
NOTE:
After the brake pads have been installed they must immediately be bonded to the brake pistons:
Step on the brake pedal to the floor and hold the pressure for one minute. This causes the brake pads to adhere to the brake pistons.
Step on the brake pedal to the floor and hold the pressure for one minute. This causes the brake pads to adhere to the brake pistons.
Follow-up work
- Install the front brake pad wear SENSOR .
- Install the front left and right WHEELS .
- COMMISSION OR BED (BREAK) IN of new brake pads and discs (18-inch high brake).