Installing the upper B-pillar trim panel
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Attach the B-pillar trim panel (1) and guide in the safety belt.
- Guide in the B-pillar trim panel (1) at the top at the roofliner and clip into the clips (2).
- Check the front and rear of the B-pillar trim panel (1) for the correct fit at the edge protection.
- Adjust the front seat completely to the front and top.
- Insert the end fitting (2).
- Replace the screw (1).
Parts: screw
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Seat belt strap fitting to seat mechanism | ||
| M10 Replace screw. |
Tightening torque | 42 Nm |