Adjusting trunk lid
NOTE:
RISK OF DAMAGE
Damage to the spindle drive.
Shifting the trunk lid manually can damage the spindle drive.
Damage to the spindle drive.
Shifting the trunk lid manually can damage the spindle drive.
- Only shift trunk lid slowly hand force.
NOTE:
TECHNICAL INFORMATION
Notes for the gap dimensions of the body form the basis of this REP and it is mandatory to observe them.
For additional information see: BODY DIMENSIONS .
Notes for the gap dimensions of the body form the basis of this REP and it is mandatory to observe them.
For additional information see: BODY DIMENSIONS .
NOTE:
Perform the steps on the right and left side.
- Undo screws (1) until the trunk lid can be shifted.
Check
- Check the gap dimensions (arrows) between trunk lid and side panels.
Result
» Gap dimensions do not correspond to the specifications.
Measure
- Adjust trunk lid.NOTE: Perform the steps on the right and left side.
- Tighten the screws (1).TIGHTENING TORQUES SPECIFICATION
Trunk lid to the hinge Hexagon screw M8 Tightening torque 28 Nm