Prepare New Part
NOTE:
RISK OF DAMAGE
Damage to the spindle drive.
Shifting the trunk lid manually can damage the spindle drive.
Damage to the spindle drive.
Shifting the trunk lid manually can damage the spindle drive.
- Only shift trunk lid slowly hand force.
NOTE:
TECHNICAL INFORMATION
Adhesive technology in the area of the outer skin (not for structural adhesion):
The bonding surfaces of the new parts may not sharpened or ground.
For more information see: 41 00... BMW/MINI BONDING INSTRUCTIONS (X3) .
Adhesive technology in the area of the outer skin (not for structural adhesion):
The bonding surfaces of the new parts may not sharpened or ground.
For more information see: 41 00... BMW/MINI BONDING INSTRUCTIONS (X3) .
NOTE:
Perform the steps on the left and right side.
- Mark the separating cut (1) on the new part to reflect the separating cut on the vehicle + approx.
15 - 20 mm material allowance and carry out the cut.
(2) = Separating cut on the vehicle
- Adjust and secure the tail cowling in combination with the trunk lid and tail lights.
- In the areas (1) and (2)
, drill bores with dia. 4.2 mm for the blind rivets,
Area Number 1 14 2 1 - Remove new part and deburr bores.