Installing the mount of the hood seal

• Feed in the mount (4) of the hood seal.
• Make sure that the mount for the hood seal (4) is correctly fitted on all adjoining components.
• Only on right side:  Clip in cable (3).
• Clip in clips (2).
• Mount the expanding rivets (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE LID FOR THE WASHER FLUID RESERVOIR .
• Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .