Remove roller sun blind
NOTE:
TECHNICAL INFORMATION
Conduct the following operation with the assistance of a second person.
Conduct the following operation with the assistance of a second person.
- Electrically extend the roller sunbhnd (2) approx. 10 cm.
Interrupt the extending of the roller sunblind (2) by disconnecting the plug connection on the roller sunblind (2).
- Lift out the cover cap (1) at left and right with a plastic wedge, first at front then at rear, from the guides.NOTE: Perform the steps on the right and left side.
- Carefully widen the retainer (1) and simultaneously move the spacers (2) to the initial position as shown.NOTE: TECHNICAL INFORMATION
Conduct the following operation with the assistance of a second person. - Press together the rear groove (1) and the front guide (2) a little.
- Lift out the shelf (3) over the front guide (2) of the roller sunblind in an upward direction.
- Pull the rear groove (1) from the shelf (3) and carefully feed out the roller sunblind downward out of the rear deck.
- Fully electrically move the roller sunblind back after feeding out from the rear deck.