Install luggage compartment wheel arch trim panel at left

• Insert the luggage compartment wheel arch trim panel (2).
• Mount the expanding rivets (1).
• Make sure the luggage compartment wheel arch trim panel (2) is correctly fitted against the edge protection of the trunk lid.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the lashing point (2).
• Tighten the associated bolt.
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Lashing point to body
  tightening torque	19 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clip in the trim (1).
• Insert the cover (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING LOADING EDGE TRIM .
• Refer to INSTALLING THE LUGGAGE COMPARTMENT FLOOR COVERING .
• Refer to REMOVING REAR SEAT BACKREST .
• Refer to INSTALLING THE REAR SEAT BENCH .
• Refer to INSTALLING BACKREST SIDE SECTION, LEFT .