Removing and installing (replacing) front left or right door trim panel (2016-2022)

Special tools required: 

• 64 1 020
• 00 9 325

When working on trim panel components, make sure that the sensitive surfaces are not scratched or damaged.

Necessary preliminary work: 

• Remove COVER ON DOOR HANDLE .

Pull out inside door handle (1) and hold open so that catch (3) on handle recess (2) can be released (see next operation).

Courtesy of BMW OF NORTH AMERICA, INC.

Working edge (1) of special tool 64 1 020 points upwards and levers out latch mechanism (2) in direction of arrow.

At the same time, lift up handle recess (3) slightly at rear so that it doesn't snap back in again.

Courtesy of BMW OF NORTH AMERICA, INC.

Detach handle recess (1) from latch mechanisms (2) with special tool 64 1 020 and remove.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Guide (1) and latch mechanisms (2) must not be damaged.

For version with handle recess lighting  :

Optical fibre (3) must not be missing or damaged.

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 51 41 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Mask front door and door trim panel in working area with plastic adhesive tape.

Detach door trim panel with special tool 00 9 325 in area A-pillar/mirror triangle starting at clips (1).

Pull off door trim panel from clamps (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Disengage Bowden cable (1) for release lever first at counter support (2) and then at door lock (3).

Installation note: 

Perform function check for door inside handle with door open and rotary striker lock closed.

Feed out door wiring harness from all brackets.

Unlock and disconnect all plug connections, then remove door trim panel.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Rubber buffers (1) must not be missing or damaged.

Replace clips (2 and 3) after each  removal.

Make sure the installation location of clips (2 and 3) is correct.

(2) Clips, natural

(3) Clip, beige 

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: 

• Modify SPEAKER TRIM  (1)
• Modify SWITCH COVER  (2)

For version without light package  :

• Install cover (3) for footwell light aperture

For version with light package  :

• Modify FOOTWELL LIGHT (3)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

After assembling the door trim panel proceed as follows:

• Open side window
• Lock with ignition key
• Check for ease-of-movement on locking button linkage
• If necessary, align linkage