Install the module bracket on the rear door

Check seal (1) of the module bracket (2) for damage.
If the seal (1) is damaged, the module carrier (2) must be replaced.

Courtesy of BMW OF NORTH AMERICA, INC.
Feed in module bracket completely with the power window and close the snap fasteners (2) .
Attach wiring harness (1) and connect the plug connections.

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten the screws (1) .

TIGHTENING TORQUES SPECIFICATION

Module bracket to door
screw	tightening torque	8 Nm

Shift the power window upwards until the side window glass correctly engages in the holder.
Remove adhesive tape.

Courtesy of BMW OF NORTH AMERICA, INC.