Install both actuators (engine removed)

NOTE: The figure shows the rear of the engine.

Position special tool 2 360 895 correctly.

Courtesy of BMW OF NORTH AMERICA, INC.
Position the actuator (1) of the exhaust side and turn in the arrow direction with the special tool 2 360 895 until the limit stops tap the clamps.

Courtesy of BMW OF NORTH AMERICA, INC.
Position the actuator (1) of the intake side and turn in the arrow direction with the special tool 2 360 895 until the limit stops tap the clamps.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The figure shows the rear of the engine.
Connect both connectors (1) lay the cable correctly.

Courtesy of BMW OF NORTH AMERICA, INC.