Remove the acoustic cover of the oil sump

WARNING: Car may slip off the vehicle hoist where components are supported.
Danger! Immobilization period-threatening injuries!

Secure the vehicle hoist against lowering and lifting.
Make sure that the vehicle does not lift off the mounting plates on the vehicle lift.

WARNING: Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly.
Danger! Immobilization period-threatening injuries!

Observe safety instructions on raising the vehicle using a vehicle hoist.
For additional information see: RAISING THE VEHICLE WITH A VEHICLE LIFT .

WARNING: Car may slip off the vehicle hoist if the weight is distributed unevenly.
Danger! Immobilization period-threatening injuries!

Ensure there is a specific weight compensation on the car.

WARNING: Heavy component falling down or tipping.
Danger! Immobilization period-threatening injuries!

Before lowering or removing the front axle: Secure the engine in the installation position.
For additional information see: MOVE THE ENGINE TO THE INSTALLATION POSITION .

WARNING: Working on 12 V electrical system.
Risk of short circuits! Risk of fire!

Make sure that there is no charger connected to the jump start terminal in the engine compartment.
Detach battery ground lead from battery.
For auxiliary batteries: Detach battery minus cables from all auxiliary batteries.

NOTE: RISK OF DAMAGE
Damage to battery terminal, the safety battery terminal or the intelligent battery sensor (IBS).
Damaged battery terminals can lead to malfunctions or vehicle electrical system faults.

Detach battery terminal from battery pole by carefully shifting to and fro. Do not pry off using a tool.

Preliminary work

Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
Refer to BRINGING FRONT COMPARTMENT LID IN THE SERVICE POSITION .
Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
Refer to REMOVING THE COVER OF THE REAR RIGHT ENGINE COMPARTMENT .
Refer to REMOVING THE RIGHT AND LEFT SIDE HOOD SEALS .
Refer to REMOVING THE ACOUSTIC COVER .
Refer to REMOVING INTAKE SILENCER HOUSING .
Refer to REMOVING TOP CLEAN AIR PIPE .
Refer to REMOVING THE COVER FOR THE CENTER ENGINE COMPARTMENT .
Refer to REMOVING THE FRONT LEFT AND RIGHT WHEELS .
Refer to REMOVING THE REAR SECTION OF THE WHEEL ARCH COVER ON THE FRONT LEFT AND RIGHT .
Refer to REMOVING THE COVER OF THE STEERING ASSEMBLY ON THE LEFT AND RIGHT .
Refer to REMOVING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
Refer to REMOVING THE UNDERBODY PROTECTION OF THE STEERING GEAR AND THRUST FIELD RESPECTIVELY .
Refer to REMOVING THE CENTER UNDERBODY PROTECTION .
Refer to REMOVING REAR UNDERBODY PROTECTION .
Refer to REMOVING THE WHEEL ARCH COVER ON THE FRONT LEFT AND BOTTOM RIGHT .
Refer to REMOVING THE UNIVERSAL JOINT ON THE STEERING GEAR .
Refer to MOVE THE ENGINE TO THE INSTALLATION POSITION .
Refer to REMOVING THE REINFORCEMENT STRUT FROM THE ENGINE MOUNTING ON THE LEFT AND RIGHT .
Refer to RELEASING THE WIRING HARNESS OF THE EPS .
Refer to IF INSTALLED: REMOVING THE SILENCER OF THE STATIONARY HEATING .
Refer to REMOVING LEFT AND RIGHT BRAKE VENTILATION DUCT .
Refer to LOOSENING THE ANTI-ROLL BAR LINK ON THE LEFT AND RIGHT FROM THE ANTI-ROLL BAR .
Refer to RELEASING THE BRAKE HOSE AT THE FRONT LEFT AND RIGHT .
Refer to IF INSTALLED: DISCONNECTING THE PLUG CONNECTIONS OF THE ACTIVE STABILIZER .
Refer to PREPARING THE MOBILE TABLE LIFT .
Refer to POSITIONING THE MOBILE LIFTING TABLE .
Refer to DETACHING THE TOP LEFT AND RIGHT WISHBONE FROM THE SWIVEL BEARING .
Refer to DETACHING THE SPRING STRUT ON THE WISHBONE ON THE BOTTOM LEFT AND RIGHT .
Refer to RELEASING THE SCREWS ON THE LEFT AND RIGHT FRONT AXLE SUPPORT .
Refer to LOWERING FRONT AXLE SUPPORT .

Precondition

Disconnect all negative battery cables.

Unlock and release the plug connection (1).
Loosen nut (2).
Guide the positive battery cable (3) out of the clamp (4) and lay to one side.

Courtesy of BMW OF NORTH AMERICA, INC.
Unlock and loosen the clamps (1).
Guide out the wiring harness section for the automatic transmission (2) and set it aside.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The following step(s) must be performed if the listed component(s) is/are installed.
Loosen screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The following step(s) must be performed if the listed component(s) is/are installed.
Loosen the holder (1).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The following step(s) must be performed if the listed component(s) is/are installed.
Feed out the transmission oil lines (1) from the holder (2) and place to one side.

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen the expanding rivet (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen the expanding rivet (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen the expanding rivet (1).
Undo Christmas tree clip (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Guide out and remove acoustic cover (1) of the oil pan.

Courtesy of BMW OF NORTH AMERICA, INC.