Installing the mount of the hood seal

NOTE: Description is for left component only. Procedure on the right side is identical.

Feed in the mount (4) of the hood seal.
Make sure that the mount for the hood seal (4) is correctly fitted on all adjoining components.
Only on right side: Clip in cable (3).
Clip in clips (2).
Mount the expanding rivets (1).

G14196448

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE LID FOR THE WASHER FLUID RESERVOIR .
Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT CENTER .