Remove the positive battery cable from the remote positive terminal to the starter motor
WARNING:
Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Observe safety instructions on raising the vehicle using a vehicle hoist.
- For additional information see: RAISING THE VEHICLE WITH A VEHICLE LIFT .
Preliminary work
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING THE COVER OF THE RIGHT DME CONTROL UNIT .
- Refer to REMOVING THE CONTROL UNIT BRACKET FOR CYLINDERS 1 TO 4 .
- Refer to REMOVING REAR UNDERBODY PROTECTION .
- Refer to REMOVING THE FRONT THRUST FIELD .
- Release the cover (1) at the detents (2) .
- Remove the cover (1)
in an upwards direction.
- Loosen nut (1) .
- Feed out the positive battery cable (3) from the stud bolt on the remote positive terminal.
- Disengage the positive battery cable (3)
on the holder (2)
.
- Unlock and disconnect the plug connection (1)
on the solenoid switch.
- Loosen nut (1)
.
- Disengage the positive battery cable (3) on the holder (1) .
- Disconnect cable tie (2) .
- Feed out and remove the positive battery cable (3) .