For replacement: Install the holder for the LED module of the light carpet
Remove the LED module for the light carpet
- Unscrew the adjustment screw (1) from the LED module (3) by turning it counter-clockwise.
- Loosen the detent (2).
- Guide the LED module (3) out of the guide (4).
Install the LED module for the light carpet
- Position the LED module (3) in the guide (4).
- Press LED module (3) into detent (2).
- Turn the adjustment screw (1) clockwise to screw it into the LED module (3).
- Clean the area (1) on the door sill trim panel (2).
Consumable
| Cleaning agent R2 | 500 ml | 83190417324 |
NOTE:
TECHNICAL INFORMATION
Notes on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: NOTES ON COMPONENT BONDING WITH ADHESIVE TAPE
Notes on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: NOTES ON COMPONENT BONDING WITH ADHESIVE TAPE
- Remove the liner from the holder (1).
- Insert the holder (1) into the door sill trim panel (2) and press evenly across the entire adhesive area.