62 11 280 Removing and installing/replacing instrument panel
WARNING:
High-voltage system - danger to life:
The following points must be strictly observed prior to starting work:
DE- ENERGIZE the high-voltage system.
Observe SAFETY INFORMATION for handling electric vehicles.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION)
.
Necessary preliminary tasks:
- Clamp off BATTERY LEAD FROM NEGATIVE CONNECTION POINT
- Move steering column completely rearwards
- Removing top steering column shroud
- Removing steering column cover
Unclip cover (1) in direction of arrow.
Installation note:
Clamps (1) on trim (2) must not be damaged or missing.
Release screw (1).
Tightening torque 62 11 1AZ .
Slacken screws (2)
Tightening torque 62 11 1AZ .
Pry out instrument panel in direction of arrow.
Disconnect plug connection (1) and remove instrument panel (2).
Replacement:
Carry out VEHICLE PROGRAMMING/ENCODING .
Check values for Condition Based Service (CBS) and correct if necessary.