51 11 Front bumper
TIGHTENING TORQUE SPECIFICATION - FRONT BUMPER
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Bumper panel on air duct, top | I01/I12 | 8 Nm | ||
| 2AZ Bumper panel on side wall | I01 | 3.5 Nm | ||
| I12 | 3.3 Nm | |||
| 3AZ Support, top, to deformation element, top | I01 | M8 | Renew screws | 28 Nm |
| I12 | M8 | 19 Nm | ||
| M6x20 | 8.8 Nm | |||
| 4AZ Deformation element, top to front axle support, | I01 | M12 | Renew screws Jointing torque Angle of rotation |
100 Nm 180 ° |
| 5AZ Carrier, bottom, to deformation element, bottom | I01 | Renew screws | 11.8 Nm | |
| I12 | 19 Nm | |||
| 6AZ Deformation element, bottom to front axle support, | I01/I12 | Renew screws | 19 Nm | |
| 7AZ Vertical strut to deformation element, top and bottom | I01/I12 | M6x16 | Renew screws | 8 Nm |
| 8AZ Support/number plate to bumper | I01/I12 | 1 Nm | ||
| 9AZ Number plate on bumper panel (thread repair) | I01/I12 | M5 | 4.5 Nm | |
| 10AZ Z-support to support | I12 | M6x16 | 8.0 Nm | |
| 11AZ Deformation element, top, to engine carrier | I12 | M8 | 28 Nm | |
| M6 | 8 Nm | |||
| 12AZ Support angle to deformation element, top | I12 | M6 | 8 Nm | |
| 13AZ Headlight fixture to deformation element, bottom | I12 | M6 | 8 Nm | |
| 14AZ Ornamental grille to bumper | I12 | 2 Nm | ||
| 15AZ Air curtain to bumper | I12 | 1.8 Nm | ||
| 16AZ i-cam holder to bumper | I12 | 1.8 Nm | ||
| 17AZ Front panel support to deformation element | I01 | 30 Nm |