51 16 480 Removing and installing or replacing front grab handle

When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).

Fold grab handle (1) downwards.

Disengage and pull out locking wedge (2) with angle screwdriver (3), as shown.

Repeat procedure on rear locking wedge (2).

Fig 1: Disengaging Locking Wedge With Angle Screwdriver

Courtesy of BMW OF NORTH AMERICA, INC.

Lightly pull grab handle (2) towards the inside by hand and hold under tension while releasing lower and upper tab (1) with screwdriver (3).

Remove grab handle (2) and place to side.

Fig 2: Pulling Grab Handle

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Only after grab handle (1) is snapped in correctly can locking wedges (2) we fully locked in position in grab handle (1).

Fig 3: Locating Grab Handle Locking Wedges

Courtesy of BMW OF NORTH AMERICA, INC.