66 53 013 Calibrating reversing camera

NOTE: Calibration of reversing camera must be carried out after the following work:

Removal and installation/replacement of reversing camera
Body repair work at rear end of vehicle

IMPORTANT: Follow instructions and specifications in procedure.
To obtain an optimum result, always adhere to the following conditions:

Vehicle standing level on headlight aiming station
Rear seat bench is unoccupied
Do not swap seats during calibration
Steering wheel in straight-ahead position
Do not move steering wheel

NOTE: Also switch on reversing camera by means of PDC button.
Calibration can only be carried out with the BMW diagnosis system.
Use of a special tool is no longer required from 03/2011!
Service functions:

Complete vehicle
Body
Assist systems