Removing and installing/sealing rear coolant end cover (N63T2) (X6 M)
Special tools required:
- 11 4 470
WARNING:
Risk of scalding! Only perform this work after engine has cooled down.
Recycling:
Catch and dispose of drained coolant in a suitable container.
Observe country-specific waste disposal regulations.
Necessary preliminary tasks:
Release all screws in area (1).
Tightening torque 11 14 5AZ .
Remove end cover.
NOTE:
Clean sealing surfaces with special tool 11 4 470.
Installation note:
Replace profile seal (1) .
Assemble engine.