Enter Vehicle Identification Number Rep-Rep-RAE7041-4108200-V.7 (X5 M)

Special tools required:

41 0 000
41 1 190
41 1 191
41 1 192

NOTE: If the stamped vehicle identification number is removed during repair work, it must be stamped in again.
Read and comply with General Notes.

Necessary preliminary tasks:

Remove FRONT RIGHT SPRING STRUT .

Set of special tools 41 1 190 for stamping vehicle identification number consists of:

Guide plate 41 1 191

Counter-support plate 41 1 192

Courtesy of VOLVO CARS CORPORATION

Position counter-support plate 41 1 192 at bottom on spring strut dome.

Position guide plate 41 1 191 at top on spring strut dome and tighten screws (1).

Courtesy of VOLVO CARS CORPORATION

NOTE: The illustration is a schematic diagram and is to be applied to the relevant vehicle type.

Insert numeral punches 41 0 000 (1) into the guide plate (2). Enter vehicle identification number.

Courtesy of VOLVO CARS CORPORATION

NOTE: In the event of partial replacement or body replacement by the workshops/garages, clearly delimit the vehicle identification number at front and rear by stamping a "+" in place of the BMW badge.
Note national regulations.