Replacing the engagement solenoid switch (X5 M)

Preliminary work needed: 

• Switch off ignition.
• Remove STARTER MOTOR. 

  Slacken nut (1).

  Remove cable head (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

  IMPORTANT: Do not twist cable head (2) when tightening, risk of short circuit to starter motor housing. 
  Tightening torque 12 41 1AZ .

  Unscrew the screws (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

  Remove the solenoid switch (1) and the spring (2).

  Detach the bolt (3).

  Installation note: 

  Check the bolt (3) for wear and grease the bolt.

  Courtesy of BMW OF NORTH AMERICA, INC.