LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2018 >> X3 M40i >> Repair and Diagnosis >> External Pages >> Different car >> Section 763 (Functional Descriptions - F25 - Charging System, Anti-Theft, Body Electrical Systems) >> Body Electrical System - Functional Description >> Setting the garage-door opener >> 2. Programming (random code hand-held transmitter)

2. Programming (random code hand-held transmitter)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

To program the integrated universal remote control, use the operating manual of the equipment to be set. Obtain information there regarding the possibility for synchronization. When programming a random code hand-held transmitter, comply with the following additional instructions:

  1. Park the vehicle within range of the radio-remote-controlled facility
  2. Program the integrated universal remote control as described previously at 'fixed-code hand-held transmitters'.
  3. Find the button on the receiver of the equipment to be set, e.g. on the drive.
  4. Press the button on the receiver of the equipment to be set. After Step 4, approx. 30 seconds remain for Step 5.
  5. Press the programmed memory button of the integrated universal remote control three times.

The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter.

scientia non olet · About LEMON Manuals