System function
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
The synchronization of the LIN bus takes place at the beginning of each message transmitted by the master. This results in a so-called "self-synchronization" of the data bus without a quartz given clock.
Components on the LIN bus, which correspond to the specifications of the data protocol LIN V2.0 have an extended scope.
- The components for V2.x are delivered with a device id and basic configuration. The final (dynamic) configuration and the allocation of the identification number takes place during the start-up via the master control unit.
- The data protocol has become more variable. As of specification V2.0, if desired, sporadic messages are also permitted in addition to the periodic messages.
- The master control units can transmit so-called multiple queries to a group of slaves. In order to reduce the load on the data bus, the addressed slaves only respond when values are modified (e.g. door contact).