65 50 170 Removing and installing/replacing cover for Central Information Display (CID)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 460

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection).

Necessary preliminary work:

Remove CENTRAL INFORMATION DISPLAY (CID)

Release screws (1).

Tightening torque: 65 50 1AZ

NOTE: To tighten screws, use special tool 00 9 460 .

Fig 1: Identifying Central Information Display Screws

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!

Carefully unlock latch mechanisms (1) with a suitable tool. Remove cover (2) from Central Information Display (3).

Fig 2: Removing Cover From Central Information Display

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Before/after assembly, cover is bolted to the Central Information Display, correct installation position must first be checked!

Installation note:

Before connecting the screw connection, check whether latch mechanisms marked with an arrow are correctly seated.

Fig 3: Locating Central Information Display Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Before connecting the screw connection, check all-round rim at the places marked with an arrow.

Fig 4: Locating Central Information Display Screw Connection

Courtesy of BMW OF NORTH AMERICA, INC.