66 53 120 Removing and installing/replacing front camera
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
Necessary preliminary work:
- Remove FRONT BUMPER PANEL
IMPORTANT:
Risk of damage!
Diaphragm (1) must not come into contact with latch mechanism (2) during removal and installation.
Diaphragm (1) must not come into contact with grease (e.g. contact with skin).
Diaphragm (1) must not come into contact with latch mechanism (2) during removal and installation.
Diaphragm (1) must not come into contact with grease (e.g. contact with skin).
If necessary, unlock and disconnect plug connection for front camera.
Insert special tool 00 9 340 between front camera (1) and latch mechanism thus protecting diaphragm.
Unlock latch mechanisms and remove front camera (1).
Installation note:
Protect diaphragm with special tool 00 9 340 .
Make sure latch mechanisms are correctly fitted.
Replacement:
Carry out VEHICLE PROGRAMMING/CODING .
Carry out service function:
- 04 Driver assistance
- All-round vision camera
- All-round vision camera programming
- All-round vision camera