66 51 030 Removing and installing/replacing camera for Lane Departure Warning

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD PROTECTION) .

Expand two-part mirror base cover (1) by pressing from below and detach.

Feed out two-part mirror base cover (1) and remove.

NOTE: Latch mechanisms of two-part mirror base cover (1) must not be damaged.

Fig 1: Removing Mirror Base Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Unclip cable in marked area.

Unlock retaining claps (2) and remove camera (3) in direction of arrow.

Fig 2: Removing Camera

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Guides (2) on camera (1) must be correctly inserted in counter supports on windscreen!

Make sure camera (1) is securely seated.

When replacing windscreen:

Carry out calibration via BMW diagnosis system:

Service functions:

Body
Lane departure warning
Calibrate camera

Fig 3: Identifying Guides On Camera
Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Heating of camera for lane departure warning is integrated in windscreen.
If heating is defective, the windscreen must be replaced!