37 14 605 Replacing left or right wheel speed accelerator sensor

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Disconnect plug connection (1) from acceleration sensor on the spring strut.

Release screw (1) and remove sensor.

Tightening torque 37 14 8AZ .

Fig 1: Identifying Plug Connection From Acceleration Sensor On Spring Strut

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check installation position.

Fit wheel speed acceleration sensor with retaining pin (1) into bore hole on the spring strut holder!

Fig 2: Identifying Wheel Speed Acceleration Sensor With Retaining Pin Into Bore Hole

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Use the diagnosis system to perform the wheel speed accelerator sensor adjustment.
-> see service function/start-up VDM.