27 21 020 Replacing radial shaft seal for output flange (ATC 450)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

27 1 440

IMPORTANT: After completing repair work, check transmission oil level and top up if necessary.
For this transfer box, use approved TRANSMISSION OIL only.

Necessary preliminary tasks:

Remove PROPELLER SHAFT

Release circlip (1).

Fig 1: Identifying Retaining Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Release output flange with three-claw extractor tool.

Lever radial shaft seal out of housing with a suitable tool.

IMPORTANT: Do not damage housing.

Fig 2: Identifying Three-Claw Extractor Tool

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Replace O-ring in output flange.

Check that O-ring is in correct position.

Fig 3: Identifying O-Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Coat sealing lips of new radial shaft seal with clean transmission oil.

Drive in radial shaft seal with special tool 27 1 440 .

Fig 4: Installing Radial Shaft Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Push on output flange
Press down output flange using 2 screwdrivers
Shim
Continue pressing output flange down until retaining groove is completely visible
Fit circlip

Fig 5: Pressing Down Output Flange Using Screwdrivers
Courtesy of BMW OF NORTH AMERICA, INC.